Keybytes Proof of Concept Puts a Microcontroller, Magnets and a Hot-Swap Socket Behind Every 1u Key

Conceptual OEM and ODM keyboard sourcing checklist

What happened

A modder publishing as notaroomba on GitHub, surfaced via KBDnews and reported by TechPowerUp, has shown Keybytes: a modular keyboard concept in which every 1u key is a self-contained block the project calls a Keybit. Each Keybit carries a full-height MX hot-swap socket, its own RISC-V CH592F microcontroller with BLE and USB, addressable RGB, and magnetic contacts on all four sides — six 1×2 mm N52 magnets per side on a 2.38 mm grid. A small FET bridge per side makes the connection polarity-independent, and the source states the layout tolerates any rotation plus 0/25/50/75% stagger between neighbouring keys.

The blocks connect to a central board (the “Keyword”) that provides USB-C, battery charging, ESD protection and pogo-pin flashing of each Keybit, with OTA updates after that. The project also lists 1u, 0.75u and 0.5u spacer blocks that pass power across gaps, a Hall variant built around a TMAG3001 three-axis sensor, and Mill-Max 3305 hot-swap sockets. The editorial itself frames the result as an interesting proof of concept rather than a finished device — no price, availability or production partner is stated.

What buyers should check

For anyone sourcing keyboards, switches or keycaps, the interesting part is architectural, not commercial. A per-key MCU changes the BOM: instead of one controller, cost and failure risk scale with key count, and firmware complexity moves to a distributed model. The rotation- and stagger-tolerant grid implies keycaps must sit correctly at 25%, 50% and 75% offsets, so legend orientation and row-profile alignment become sourcing questions rather than design footnotes. Buyers should also note that only 1u blocks are described, leaving spacebar and long-modifier support unaddressed in the source.

Factory-side take

Treat this as a design-direction signal, not a procurement option. Conditional questions worth putting to a supplier: if per-key control were ever quoted, what happens to unit cost and rework rates when each key carries its own MCU and magnets? Which magnetic-switch or Hall-sensor families would a factory support if a Hall variant were requested, and what tolerance would keycap stems need at non-zero stagger? How would a 1u-only lattice handle a 6.25u spacebar — an inferred gap, since the source does not say? Finally, ask for evidence of cycle life on magnetic edge contacts, which the source does not quantify.

Original reporting: www.techpowerup.com — Modder Builds Keybytes: Modular Magnetic Keyboard System Made with Single Key Building Blocks (2026-11-13).

Planning an OEM/ODM keyboard or keycap run? Tell us your layout, materials, quantity and timeline.

Conceptual keyboard switch procurement checklist
Switch procurement questions for buyers; not a test of the reported switch.
EN|ZH